2009 air arms s410 leaking ,

no avatar
fife
Posts: 8
Joined: Fri Feb 05, 2016 11:28 pm

2009 air arms s410 leaking ,

Wed Jun 05, 2019 8:50 am

HI All, Got my mates 2009 air arms s410 leaking ,he told me he put to much air in it so been a good mate i said i would renew all the O rings for him, replaced the cylinder and filler probe ones , put some air in and its comeing out of where the bolt goes in that holds the shock on , I slid the barrol out but there was no O rings in there but i could see a brass bit infrount of were the barrol goes but i dont no how that brass bit comes out i can see it has O ring on it, any idea thanks bob.

no avatar
TenMetrePeter
Posts: 1024
Joined: Wed Jun 29, 2016 5:40 pm
Location: Luton Beds UK

Re: 2009 air arms s410 leaking ,

Wed Jun 05, 2019 4:39 pm

The brass barrel collar will not leak continuously. It only affects point of firing and usually has no O rings but may have one if its a bad fit. It’s not the problem here though, either way.
(The brass collar is supposed to be loctited to the barrel).
If you have a leak near the stock bolt hole are you sure it isn't the gauge block leaking where it meets the body? That would leak continuously.
Soap it up with a bit of Fairy and water on a brush. There's 2 O rings at the joint I think.

no avatar
fife
Posts: 8
Joined: Fri Feb 05, 2016 11:28 pm

Re: 2009 air arms s410 leaking ,

Thu Jun 06, 2019 12:38 pm

HI Peter, thanks for that iformation its been a big help THANKS BOB.

no avatar
fife
Posts: 8
Joined: Fri Feb 05, 2016 11:28 pm

Re: 2009 air arms s410 leaking ,

Sat Jun 22, 2019 10:23 am

HI , I update the gun is spot on now and back to my mate he was pleased ,thanks bob.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests