Getting to the hammer on a tdr 410

no avatar
Simshaz
Posts: 37
Joined: Wed Oct 21, 2015 9:41 am

Getting to the hammer on a tdr 410

Mon Apr 08, 2019 9:34 pm

Hi
I have removed the anti tamper to allow me to strip the tdr so I am left with the trigger unit and the slide and rail. All this is still attached and on a 410 I would undo the Allen key on the back to separate the 2 halves to get to the hammer and spring. How do I do this on the TDR.
Air Arms S510 Ultimate Sporter .177, MTC Mamba Lite Scope

no avatar
Roger5
Posts: 1071
Joined: Sat Jul 25, 2015 8:04 am
Location: Hampton middlesex

Re: Getting to the hammer on a tdr 410

Mon Apr 08, 2019 10:29 pm

It is held with two pins and it just pulls apart. Rog

no avatar
Simshaz
Posts: 37
Joined: Wed Oct 21, 2015 9:41 am

Re: Getting to the hammer on a tdr 410

Mon Apr 08, 2019 11:15 pm

Thanks, roughly where are they and do I need to drift them out
Air Arms S510 Ultimate Sporter .177, MTC Mamba Lite Scope

no avatar
Roger5
Posts: 1071
Joined: Sat Jul 25, 2015 8:04 am
Location: Hampton middlesex

Re: Getting to the hammer on a tdr 410

Tue Apr 09, 2019 9:01 am

The two pins are locating pins, there is nothing to drift, it will separate if you give it a wiggle and pull it apart. Rog

no avatar
Simshaz
Posts: 37
Joined: Wed Oct 21, 2015 9:41 am

Re: Getting to the hammer on a tdr 410

Tue Apr 09, 2019 9:04 am

Cheers
Will try that later on.
Air Arms S510 Ultimate Sporter .177, MTC Mamba Lite Scope

no avatar
Simshaz
Posts: 37
Joined: Wed Oct 21, 2015 9:41 am

Re: Getting to the hammer on a tdr 410

Tue Apr 09, 2019 8:04 pm

Rog
Worked a treat, all polished and back together. May fit a de-pinger whilst the tube is off still
Many many thanks
Air Arms S510 Ultimate Sporter .177, MTC Mamba Lite Scope

Post Reply

Who is online

Users browsing this forum: No registered users and 23 guests