Hi I have just purchased a used air arms TX200 HC, I was going to buy new but managed to get a used one a great deal cheaper, the only issue I have is not sure how old it is, the gun has different ball bearing holder than the new ones, its round where the newer ones have a square
Also it’s been tuned but I have the original bits if required.
3 posts Page 1 of 1
The round holder was used up until a few years ago, so the gun could still be pretty new. I have the round holder on both my full length MarkIII TX's because I think they look better than the newer slab sided holder. They're also a direct swap, if you can find one. The slab side holder has always been on the full length MarkIII guns.
Users browsing this forum: No registered users and 0 guests