Air arms TX200 HC

no avatar
Andrew Tofton
Posts: 1
Joined: Sat May 05, 2018 8:44 am

Air arms TX200 HC

Sat May 12, 2018 5:25 pm

Hi I have just purchased a used air arms TX200 HC, I was going to buy new but managed to get a used one a great deal cheaper, the only issue I have is not sure how old it is, the gun has different ball bearing holder than the new ones, its round where the newer ones have a square
Also it’s been tuned but I have the original bits if required.

no avatar
Posts: 310
Joined: Mon Feb 16, 2015 2:37 am

Re: Air arms TX200 HC

Sat May 12, 2018 7:13 pm

The round holder was used up until a few years ago, so the gun could still be pretty new. I have the round holder on both my full length MarkIII TX's because I think they look better than the newer slab sided holder. They're also a direct swap, if you can find one. The slab side holder has always been on the full length MarkIII guns.

no avatar
Posts: 10
Joined: Tue Dec 06, 2016 8:27 pm

Re: Air arms TX200 HC

Mon May 14, 2018 2:21 pm

If you Email Air Arms the serial number, they will tell you the exact age

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest