Breach seal and shim
Posted: Sun Mar 22, 2015 9:04 pm
Evening all
My first post, thanks in advance.
I was advised due to my barrel blocking that i needed to change my breach seal on my S410.
I have been having problems with pellets blocking the barrel as they are not loading cleanly, it occurs with no mag in so its not that.
I have stripped the gun and tbh the seal looked ok but I have been unable to get the brass shim out of the rifle.
Anyway, a fella from the local club offered to change it for me if I order the parts and told me to get them from Julian Bond.
So could I please go about ordering the shim and seal ? I would also like a spare set of seals incase I have lost anything during my ameturish strip down of the rifle
I was told there are two sizes and that you may need the serial off the air cylinder Dom 07/2012 SAE 4130bks inspect annually 49653
Any additional advice would be greatly received
Thanks
Ash
My first post, thanks in advance.
I was advised due to my barrel blocking that i needed to change my breach seal on my S410.
I have been having problems with pellets blocking the barrel as they are not loading cleanly, it occurs with no mag in so its not that.
I have stripped the gun and tbh the seal looked ok but I have been unable to get the brass shim out of the rifle.
Anyway, a fella from the local club offered to change it for me if I order the parts and told me to get them from Julian Bond.
So could I please go about ordering the shim and seal ? I would also like a spare set of seals incase I have lost anything during my ameturish strip down of the rifle
I was told there are two sizes and that you may need the serial off the air cylinder Dom 07/2012 SAE 4130bks inspect annually 49653
Any additional advice would be greatly received
Thanks
Ash