S300 valve body

[Teggwynn]

Hey all, newbie here to the forum! I have recently bought a early s300 and its bit of a project, its been leaking air for years and hence not been used. After stripping it down the valve seat in the body is dog rough and the cause of the issues, dont suppose anyone here would have one for sale please??

Matt

[eboswan]

Welcome,Julian (BGALTD)will be along shortly too help you out.

[Teggwynn]

Thanks bud

[bgaltd]

Hey all, newbie here to the forum! I have recently bought a early s300 and its bit of a project, its been leaking air for years and hence not been used. After stripping it down the valve seat in the body is dog rough and the cause of the issues, dont suppose anyone here would have one for sale please??

Matt

good to speak to you Matt , fingers crossed we can get it sorted .

[Teggwynn]

Hey all, newbie here to the forum! I have recently bought a early s300 and its bit of a project, its been leaking air for years and hence not been used. After stripping it down the valve seat in the body is dog rough and the cause of the issues, dont suppose anyone here would have one for sale please??

Matt

good to speak to you Matt , fingers crossed we can get it sorted .

Thank you, pleasure to speak to someone with such a knowelge! I’v had my orignal valve back from machine shop and they have done a peach of a job fair play. but and its a BIG but, where they have machined the valve face back perfect they have unearthed 4 very small hairline cracks around the hole the valve fits through. I can only assume that the cracks are from a issue during the orignal manufacture

[bgaltd]

Hey all, newbie here to the forum! I have recently bought a early s300 and its bit of a project, its been leaking air for years and hence not been used. After stripping it down the valve seat in the body is dog rough and the cause of the issues, dont suppose anyone here would have one for sale please??

Matt

good to speak to you Matt , fingers crossed we can get it sorted .

Thank you, pleasure to speak to someone with such a knowelge! I’v had my orignal valve back from machine shop and they have done a peach of a job fair play. but and its a BIG but, where they have machined the valve face back perfect they have unearthed 4 very small hairline cracks around the hole the valve fits through. I can only assume that the cracks are from a issue during the orignal manufacture

bugger . you'll just have to send it to me for scrapping now ............





























................. or we can adapt the 400 valve housing as discussed on the phone . give me a ring if i can help .

rgds.

Julian

[Teggwynn]

Little update, the valve body with the very small hairline cracks is sealing and holding air just perfect To my total suprise! The gun was charged to 200bar and left a few days and hadnt dropped a single psi..
what i’m after is a multishot conversation now for it, would any body know if a s410 breach would fit?

[bgaltd]

that i'm not sure about .