Page 1 of 1
Your top three S200 mods would be:
Posted: Thu May 21, 2015 1:22 pm
by oyster
Other than just shiny bits, what would your top three improvements be?
Mine are 1. regulator; 2. improved bolt action; 3. silencer
Re: Your top three S200 mods would be:
Posted: Thu May 21, 2015 2:17 pm
by daverobson
1. Polished trigger
2. Pressure gauge & quickfill
3. Extended cylinder
Re: Your top three S200 mods would be:
Posted: Thu May 21, 2015 6:34 pm
by kevingambrell
Trigger blade,
Bolt handle.
But pad.
Reach forward scope mounts (get rid of the block on the barrel).
The trigger group isnt that bad out of the box if you ignore the blade itself. The grub screws that transfer the movement from the blade to the first sear need looking at but past that its a well sorted trigger unit.
Bolt handle is a little small for me, but its still useable.
The comb on the stock sits a bit low for me so an adjustable but pad had to be fitted.
The scope mount that sits on the barrel is a complete cock up of design. I took mine off and bought a set of reach forward mounts. Nothing needs or wants to clamp to any part of the barrel.
Re: Your top three S200 mods would be:
Posted: Thu May 21, 2015 7:29 pm
by daverobson
I think my S200 was made on a Monday morning after the trigger fitter had a heavy weekend!
It has FOUR stages to it!
Did you know the Czech Republic has the highest beer consumption in the world.
http://en.wikipedia.org/wiki/Beer_in_the_Czech_Republic http://en.wikipedia.org/wiki/Beer_consu ... by_country
Re: Your top three S200 mods would be:
Posted: Thu May 21, 2015 9:14 pm
by Raj
daverobson wrote:I think my S200 was made on a Monday morning after the trigger fitter had a heavy weekend!
It has FOUR stages to it!
This is a well known fact. You can get it back to 2 stage by rounding off the ends of the 2 grub screws .....
Sorry guys ... I just had a pang for the Timinder Trigger Tune guide off the old AAOC
Re: Your top three S200 mods would be:
Posted: Thu May 21, 2015 9:25 pm
by Dan
Raj tell them about the Jesus pin?