AirArms S200 problem

[maddoghutty]

Hi guys and ladies I would like to introduce myself my name is maddoghutty and I love air rifleing. I have just taken it back up I first bought a gamo hunter 440 2.2 springer which really got me back into the game full power great rifle. I then just purchased a AA S200 well modded paid a lot more than I should but happy. But have cycling issue on multi mag cycling properly if any of you guys have had this problem and fixed could you please msg me asap has i am depending to use rifle in 2 days but with this issue its a problem. Hope you can help, thx

[Blackbaronfish]

Could you fill out your location please.
Welcome to the AAOC

BBF

[neil]

there has been loads posted here and other places about mag problems but in order to point you in the right direction more info is needed about what problem your having.
3 main problems that I know about are:
1, bolt probe rips`o` rings apart, check the alignment when you drop the mag into the housing, if it does not line up it can be adjusted with a small allen key visible on the underside of the mag housing
2,bolt probe lines up when the mag is dropped in but still tears seals, this one is down to the amount of throw the mag has, bit harder to fix as in my experience with them its down to the profile of the brass spring inside the housing, I was lucky, I had two of them so used the good one as an example to copy
3,mags stick, no idea on this one really, when I had it happen to me I measured every single dimension and found no difference between good and bad mags, no amount of lube helped, as daft as it sounds this one was cured by carrying the mags in my pocket with loose change for a while, this seemed to polish it up a bit and never had any more problems
please bear in mind that this is my own experience with them and this only applies to the AA conversion kit, if you have any other make kit fitted then ignore all the above

[maddoghutty]

Could you fill out your location please.
Welcome to the AAOC

BBF

Humberside, Hull

[maddoghutty]

Hi guys I live in Humberside,Hull and every time I put a mag in it will not load from the off in less I move it round with my fingure has I said I'm new to the air arms and multi shot but I really do think it might be either the brass cycle plate. Has I have noticed that cycles the mag round or the allignment. Could you tell me the positioning or about the brass plate thx for your replys.

[neil]

Hi guys I live in Humberside,Hull and every time I put a mag in it will not load from the off in less I move it round with my fingure has I said I'm new to the air arms and multi shot but I really do think it might be either the brass cycle plate. Has I have noticed that cycles the mag round or the allignment. Could you tell me the positioning or about the brass plate thx for your replys.

see point 1 on my post, easily adjusted from underneath

[maddoghutty]

Thx for reply I cannot see how it cannot be lined up if the bolt goes through if I line the mag up without no pellet but underneath the mag housing where is the allen key underneath I cannot see one on mine could you send images please so I can check against mine i would be most thankfull

[doggo]

Never owned a s200 do the mags self index?.