sloppy bolt
sloppy bolt
Hi all, I have just purchased a new s400. The bolt appears to move up and down far more freely than my last 400 and it lacks the positive click when you close it after inserting a pellet. Is this normal. Regards
Re: sloppy bolt
hi mate. its a bit hard to tell if the bolt on your last gun was a bit to tight. or the bolt on your new gun is a bit to lose. but if the bolt is smooth. and you get no blow back from the bolt probe. then it should be fine. if the bolt has lots of play and can move around when cocked ( up and down side to side ) then you could have a problem.
This is my rifle. There are many like it, but this one is mine. It is my life. I must master it as I must master my life. Without me my rifle is useless. Without my rifle, I am useless.
-
Blackbaronfish
- Posts: 3690
- Joined: Sun Feb 15, 2015 6:20 pm
- Location: Nuneaton
Re: sloppy bolt
Sounds ok to me as long as the bolt hold its position.
BBF
BBF
Did I mention that I'm the only one to have attended EVERY meet since we started
Re: sloppy bolt
Do you mean if it holds in the upward position when pulled back to cock. Thanks
-
Blackbaronfish
- Posts: 3690
- Joined: Sun Feb 15, 2015 6:20 pm
- Location: Nuneaton
Re: sloppy bolt
No holds down in the closed position
BBF
BBF
Did I mention that I'm the only one to have attended EVERY meet since we started
Re: sloppy bolt
Check that it has it's o ring intact. You could put an extra one on there to snug things up a bit.
AA s410K .177
BSA R10 .177 Super carbine. (Blacky)
BSA R10 .177 Super carbine. (Blacky)
Who is online
Users browsing this forum: No registered users and 65 guests