Page 1 of 1

What can I do?

Posted: Sat Apr 18, 2015 10:02 am
by devonhunter
To make my s410 a better rifle to shoot and use, as in what can I spend on it to make is better in accuracy consistency air usage and general betterness. :D

Re: What can I do?

Posted: Sat Apr 18, 2015 1:07 pm
by raygun
The biggest single improvement you could make is to get an adjustable cheek piece done.

ATB
Ray.

Re: What can I do?

Posted: Sat Apr 18, 2015 1:20 pm
by Blackbaronfish
As above as repeating your eye alignment is crucial.

BBF

Re: What can I do?

Posted: Sun Apr 19, 2015 5:49 am
by devonhunter
Ok cheers chaps

Re: What can I do?

Posted: Sun Apr 19, 2015 8:05 am
by Raj
Trigger tune and custom trigger blade.
Polish internals.
Float the cylinder. :)

Re: What can I do?

Posted: Sun Apr 19, 2015 8:25 am
by fishingfordragons
This is an adjustable cheekpiece which was carried out by Warren Edwards on Shooting the Breeze.
Image

Dave

Re: What can I do?

Posted: Sun Apr 19, 2015 8:58 am
by devonhunter
Raj wrote:Trigger tune and custom trigger blade.
Polish internals.
Float the cylinder. :)


Have never looked at the trigger to be honest it is ok to be honest but can be a little gritty. I will free float the cylinder, looked at it the other day. And maybe the rowan engineering trigger

Re: What can I do?

Posted: Sun Apr 19, 2015 9:51 am
by roadrunner
Trigger job,noticed how bad my 400 trigger was after shooting a daystate,also the power had crept up on mine to the upper limit and i had mine took back to 11.4 and its as sweet as a nut,the trigger only required the lower two sear contact points polishing,its now quiet easy to hit a 5p at 45 yards over and over again and iam no sharp shot

Re: What can I do?

Posted: Sun Apr 19, 2015 10:25 am
by doggo
Hammer rail polish makes it more consistant plus a few extra shots worth doing.