What can I do?

no avatar
devonhunter
Posts: 66
Joined: Mon Feb 16, 2015 8:59 pm

What can I do?

Sat Apr 18, 2015 10:02 am

To make my s410 a better rifle to shoot and use, as in what can I spend on it to make is better in accuracy consistency air usage and general betterness. :D
AA S410 .22 LH walnut stock MTC viper 10x44 harris 1A2-H bipod

User avatar
raygun
Posts: 397
Joined: Sun Feb 15, 2015 3:41 pm

Re: What can I do?

Sat Apr 18, 2015 1:07 pm

The biggest single improvement you could make is to get an adjustable cheek piece done.

ATB
Ray.

User avatar
Blackbaronfish
Posts: 3690
Joined: Sun Feb 15, 2015 6:20 pm
Location: Nuneaton

Re: What can I do?

Sat Apr 18, 2015 1:20 pm

As above as repeating your eye alignment is crucial.

BBF
Did I mention that I'm the only one to have attended EVERY meet since we started

no avatar
devonhunter
Posts: 66
Joined: Mon Feb 16, 2015 8:59 pm

Re: What can I do?

Sun Apr 19, 2015 5:49 am

Ok cheers chaps
AA S410 .22 LH walnut stock MTC viper 10x44 harris 1A2-H bipod

User avatar
Raj
Posts: 2005
Joined: Sun Feb 15, 2015 9:36 pm
Location: Rugby

Re: What can I do?

Sun Apr 19, 2015 8:05 am

Trigger tune and custom trigger blade.
Polish internals.
Float the cylinder. :)
“It's the Indian, not the arrow"

User avatar
fishingfordragons
Posts: 21
Joined: Tue Feb 17, 2015 11:43 am

Re: What can I do?

Sun Apr 19, 2015 8:25 am

This is an adjustable cheekpiece which was carried out by Warren Edwards on Shooting the Breeze.
Image

Dave

no avatar
devonhunter
Posts: 66
Joined: Mon Feb 16, 2015 8:59 pm

Re: What can I do?

Sun Apr 19, 2015 8:58 am

Raj wrote:Trigger tune and custom trigger blade.
Polish internals.
Float the cylinder. :)


Have never looked at the trigger to be honest it is ok to be honest but can be a little gritty. I will free float the cylinder, looked at it the other day. And maybe the rowan engineering trigger
AA S410 .22 LH walnut stock MTC viper 10x44 harris 1A2-H bipod

User avatar
roadrunner
Posts: 294
Joined: Tue Feb 17, 2015 1:12 pm

Re: What can I do?

Sun Apr 19, 2015 9:51 am

Trigger job,noticed how bad my 400 trigger was after shooting a daystate,also the power had crept up on mine to the upper limit and i had mine took back to 11.4 and its as sweet as a nut,the trigger only required the lower two sear contact points polishing,its now quiet easy to hit a 5p at 45 yards over and over again and iam no sharp shot

no avatar
doggo
Posts: 19
Joined: Sun Feb 15, 2015 10:49 am

Re: What can I do?

Sun Apr 19, 2015 10:25 am

Hammer rail polish makes it more consistant plus a few extra shots worth doing.

Post Reply

Who is online

Users browsing this forum: No registered users and 51 guests