My S310 is back up and shooting now all the work is done
Posted: Sat Feb 20, 2021 10:20 pm
Ok well I decided that apart from fitting the Gauge and quick fill kit I thought I would replace all the seals well that was the plan 
this is the list of parts that was replaced.
All O rings replaced
S319 Trigger weight spring Original was bent
S331 Mainspring Original Had rust on
S370 Firing Valve Original Heavily scored and worn.
S502 Bolt Housing Bush Original worn elliptical
S535 Barrel seal Carrier Original worn to a .25 caliber instead of .177
Bolt handle bolt as the one that was there was too short only holding by 3 threads
Rear stock screw as the one in there was some horrible chewed up slotted thing
Lane Regulators Gauge and probe fill kit
this is the list of parts that was replaced.All O rings replaced
S319 Trigger weight spring Original was bent
S331 Mainspring Original Had rust on
S370 Firing Valve Original Heavily scored and worn.
S502 Bolt Housing Bush Original worn elliptical
S535 Barrel seal Carrier Original worn to a .25 caliber instead of .177
Bolt handle bolt as the one that was there was too short only holding by 3 threads
Rear stock screw as the one in there was some horrible chewed up slotted thing
Lane Regulators Gauge and probe fill kit