Page 1 of 1
standard loading bolt
Posted: Fri Jul 10, 2020 8:20 am
by tapps
i've purchased a new (BLACK) loading bolt for my new .177 s410F,any idea of the allen key needed to get the original loading bolt off, is the original allen bolt coated with lock tight.
Re: standard loading bolt
Posted: Fri Jul 10, 2020 8:59 am
by tapps
tapps wrote: ↑Fri Jul 10, 2020 8:20 am
i've purchased a new rowan engineering (BLACK) loading bolt for my new .177 s410F,any idea of the allen key needed to get the original loading bolt off, is the original allen bolt coated with lock tight.
Re: standard loading bolt
Posted: Fri Jul 10, 2020 12:09 pm
by Roger5
Loctite and AirArms
Rings a bell does that
Re: standard loading bolt
Posted: Fri Jul 10, 2020 7:06 pm
by billywhizz
try using some heat on the bolt/thread, hair dryer or hot air gun ( not too hot tho). warm it up then try undoing the bolt.
Re: standard loading bolt
Posted: Sun Jul 12, 2020 5:06 pm
by tapps
tapps wrote: ↑Fri Jul 10, 2020 8:59 am
tapps wrote: ↑Fri Jul 10, 2020 8:20 am
i've purchased a new rowan engineering (BLACK) loading bolt for my new .177 s410F,any idea of the allen key needed to get the original loading bolt off, is the original allen bolt coated with lock tight.
i've managed to get the allen key bolt out with a little heat using a hair drier, the loading bolt is stuck on the loading bolt assembly,is it just a simple case of applying more heat to get the original one off, i would like to fit my rowan engineering black bolt, it's never straight forward.....
Rings a bell does that 