S410 TDR

[Roger5]

Does anyone know or could measure the soft backpack that comes with the S410 TDR thanks Rog

[Roger5]

Does anyone know or could measure the soft backpack that comes with the S410 TDR thanks Rog

Found it 65mm

[Roger5]

And just bought the TDR, sold an S410 .22 to help towards the cost, and its the S410 TDR .177 not the new S510 s/l

[tonyc]

Can you let me know the shot count, Rog.
I believe the .177 only came with the longer barrel... can't remember the length offhand, but I recall the original TDR was in .22 only, then AA increased the barrel length and released the .177

[Roger5]

Hi Tony, will do, not had the chance to shoot it yet, picked it up from Lambert of Ringwood last Friday, doesn't look like it's had much use though. Cheer's Rog

[Roger5]

Played with it today, as expected sweet spot starts at 160bar then I'm getting 40 all on the money, it's now in bits A/T removed all cleaned up i.e. Hammer rail, sorted trigger, will finish it tomorrow, and see if there's any improvement, it's very accurate, just like all my other A/As

[John814ce]

I know aa set the firing pot to 57mm on the tdr's/carbines (the guns with the 30cm cylinders), And 58mm on the 40cm cylinders. Not sure about fac 50cm cylinders. But if you want to tighten the 40 sweetspot shots to 3-5 fps on the carbines/30cm cylinders, then set the pot at 56mm. Also you lose the fire ping sound in the cylinder when shortening the pot length to around 56mm- 56.5mm, If you didn't already know.