Hi
Started checkering the new stock. Its 20 lpi checkering.
Marking out the borders with a sharp knife and a single line cutter.
20150228_180240 by kgambrell2000, on Flickr
First few lines marked out but not to depth. This bit uses a following cutter and the single line cutter to deepen.
20150228_185314 by kgambrell2000, on Flickr
A few more lines cut.
20150228_200028 by kgambrell2000, on Flickr
A selection of the tools used.
20150228_185337 by kgambrell2000, on Flickr
A few in close up.
20150228_204241 by kgambrell2000, on Flickr
20150228_204259 by kgambrell2000, on Flickr
Only three and a half more pannels to cut!
Checkering the new stock
Re: Checkering the new stock
That's very impressive.
Lots of patience and endeavor needed.
ATB
Ray.
Lots of patience and endeavor needed.
ATB
Ray.
Re: Checkering the new stock
That's serious stuff. I'd be afraid in case I slipped
- Blackbaronfish
- Posts: 3690
- Joined: Sun Feb 15, 2015 6:20 pm
- Location: Nuneaton
Re: Checkering the new stock
Where did you get the tools from.
BBF
BBF
Did I mention that I'm the only one to have attended EVERY meet since we started
- kevingambrell
- Posts: 87
- Joined: Mon Feb 16, 2015 8:34 pm
Re: Checkering the new stock
Blackbaronfish wrote:Where did you get the tools from.
BBF
I buy mine from Midway UK ( Now Brownels). Iv had these ones about 5 years the cutters are still going strong.
Who is online
Users browsing this forum: No registered users and 27 guests