Air Arms Owners Club

Hi, does any of our tinkeres know how to remove the grip ( stock ) from the above pistol, any advice welcome, thanks.

ATB John.

Haven't got a clue .... but Welcome Back, Mr.Bailey !!!
I do know that we have one or two owners of the Alfa Project on here so it wont be long before you get an answer.

Now, probably talking through my back side but the action is not too dissimilar to the S200 breech block. Perhaps it is a draw bolt system through the pistol grip? If you unscrew the air cylinder, there may just be a nut that releases the action from the woodwork.

There is strip down info in the tech section which may be of use. dave

Thanks for the replays guys, but still no luck removing the dammmm thing

ATB John.

Mine came with a tube type spanner that has got 2 tongue prongs that fit on the end of the filling nozzle. If you take
The dust cover off you can see 2 slots in the black tube that is the nut holding the grip on

Hi Ericb, yes iv done that,,,, but no luck the air tube is to big for the grip to come off thanks for the reply,

atb john.

Hello John
May be daft reply but do you know the grip is actually 2 parts it sounds to me like the 3 dowels are a bit tight
On yours. Tried to take a picture but it's too big.