Page 1 of 1
MDE Air Cylinder
Posted: Wed Jul 29, 2015 8:49 pm
by Saltire
Does anyone use the MDE Air Cylinder? How have you found it with the supplied regulator. I was having a look at them on the best fittings site?
http://www.bestfittings.co.uk/shopdi...=7+Ltr+300+BAR
Re: MDE Air Cylinder
Posted: Wed Jul 29, 2015 9:47 pm
by ajs
I have a 3L 300bar MDE cylinder, no problems at all. The valve is smooth and easy to use.
Also got 2 Hydrotech tanks (7L & 3L, both 300bar), again both are smooth and easy to use (had to have the valve changed on the 7lt due to it sticking).
All 3 tanks get a bit lively when they're freshly filled though, caution and a steady hand required
Re: MDE Air Cylinder
Posted: Wed Jul 29, 2015 9:48 pm
by Iced Tiger
I bought my 12l from BAR, the supplied regulator is fine, no problems.
http://www.airgunbuyer.com/Showproducts ... 0Equipment
Re: MDE Air Cylinder
Posted: Wed Jul 29, 2015 10:07 pm
by Blackbaronfish
I have had one for 11 years with out any problems
BBF
Re: MDE Air Cylinder
Posted: Thu Jul 30, 2015 8:37 am
by raygun
Most of the cylinders are made by Faber but the MDE valve set up is a good one.
The "Slow fill" one can make life easier, especially when newly filled.
ATB
Ray.
Re: MDE Air Cylinder
Posted: Thu Jul 30, 2015 10:12 am
by Mark112
Changed the gauge on mine for one of these:-
http://www.bestfittings.co.uk/shopexd.asp?id=718 Much easier to read for us with less than perfect eyesight
Re: MDE Air Cylinder
Posted: Thu Jul 30, 2015 11:03 am
by Gnome of the Woods
Technical note, they are just valves not regulators on air gun charging kits.
Re: MDE Air Cylinder
Posted: Fri Jul 31, 2015 5:25 pm
by Saltire
Many thanks to all you posted
