TX200 HC underlever bumper

[Stokie99]

I put an O-ring on simply.
That's it. Who cares?

When you say oring do you mean you have glued it in place flat??

[Stokie99]

I have a TX200 MK 3. I've replaced the rubber bumper twice, as it's located right where I clasp the underlever. It does screw in ....but I pulled them out because the bumpers are made of soft rubber( I think that my nails snag them). Someone on this forum (the old one) suggested making the bumper out of an old fan belt. It works great. As the fan belt material is harder and fibre reinforced it dosen't tear out easily. I went to my local garage and got a broken fan belt gratis.

ATB

Junaid

Photos would be good stokie99

[doggo]

The o ring slides over the cocking arm if i remember right there is a groove for it to sit in .