Checkering the new stock

[kevingambrell]

Hi
Started checkering the new stock. Its 20 lpi checkering.

Marking out the borders with a sharp knife and a single line cutter.

20150228_180240 by kgambrell2000, on Flickr

First few lines marked out but not to depth. This bit uses a following cutter and the single line cutter to deepen.

20150228_185314 by kgambrell2000, on Flickr

A few more lines cut.

20150228_200028 by kgambrell2000, on Flickr

A selection of the tools used.

20150228_185337 by kgambrell2000, on Flickr

A few in close up.

20150228_204241 by kgambrell2000, on Flickr

20150228_204259 by kgambrell2000, on Flickr

Only three and a half more pannels to cut!

[raygun]

That's very impressive.

Lots of patience and endeavor needed.

ATB
Ray.

[Phil B]

That's serious stuff. I'd be afraid in case I slipped

[Blackbaronfish]

Where did you get the tools from.

BBF

[kevingambrell]

Where did you get the tools from.

BBF

I buy mine from Midway UK ( Now Brownels). Iv had these ones about 5 years the cutters are still going strong.