Crinkle washers

[Hairybiker59]

Have stripped my s410 to give the rail and hammer a polish has well has fitting the bottle brush to de ping.is it worth me fitting the crinkle washers with it only being the two sear trigger and not the three sear

[Gnome of the Woods]

Yes is the simple answer, it releases the sears of any tension so improving feel and connection.

[wezdavo]

I found the crinkle washers gave the sears too much lateral movement as they were only 0.4mm thick...

I measured the internal housing at 4.75mm deep and the sears a 3.00mm so in my case there was 1.00mm of movement, which doesn't sound much but it is 33% of the sear!

I replaced mine for stainless washers to tighten the tolerance..

I have also made and fitted a spring guide for the trigger weight preload spring to stop it buckling and catching the inner housing..

All a bit anal but I like faffing around