Page 1 of 1
S410 2004 fac extra baffles removal from shroud
Posted: Fri Dec 15, 2017 6:55 pm
by Bill-Kerr
Hi i just bought a new shroud from air arms i thought it would come with baffles fitted, no just an empty tube, how do i remove the baffles from old shroud ???
Re: S410 2004 fac extra baffles removal from shroud
Posted: Fri Dec 15, 2017 8:55 pm
by bgaltd
Bill-Kerr wrote:Hi i just bought a new shroud from air arms i thought it would come with baffles fitted, no just an empty tube, how do i remove the baffles from old shroud ???
you just need to push them out , the bit at the end either screws out or will need knocking out depending on which shroud you have
.
Re: S410 2004 fac extra baffles removal from shroud
Posted: Fri Dec 15, 2017 9:16 pm
by Blackbaronfish
It’s not unusual for someone to have loctite a few.
If they have then just warm it up with a hot hair dryer
BBF
Re: S410 2004 fac extra baffles removal from shroud
Posted: Fri Dec 15, 2017 11:26 pm
by Bill-Kerr
Thanks for the replies will heat it up and try to push it out no thread on either end of shroud.
Re: S410 2004 fac extra baffles removal from shroud
Posted: Sat Dec 16, 2017 12:46 pm
by Bill-Kerr
Once again thanks for the help, but the baffles had all went brittle they had been in there from 2004 so i will have to order new ones.
Re: S410 2004 fac extra baffles removal from shroud
Posted: Sat Dec 16, 2017 1:31 pm
by Blackbaronfish
Send julian a pm or go on his sales thread
BBF
Re: S410 2004 fac extra baffles removal from shroud
Posted: Sat Dec 16, 2017 2:11 pm
by eboswan