Page 1 of 1
Newbie
Posted: Tue Nov 13, 2018 4:24 pm
by Tom1954
Hi all i am new to.air arms just bought a s410 c it is accurate but the bolt is very heavy had blisters on my finger is this normal.
Re: Newbie
Posted: Tue Nov 13, 2018 8:22 pm
by eboswan
Put a light smear of light oil on the bolt shaft and see if that makes a different
Is it seating the pellet easily?
Re: Newbie
Posted: Tue Nov 13, 2018 9:05 pm
by Blackbaronfish
Make sure you grip the bolt nearer to the central shaft rather than the ball end
BBF
Re: Newbie
Posted: Tue Nov 13, 2018 10:22 pm
by eboswan
Never ever grab the bell end unless it's your own
Re: Newbie
Posted: Wed Nov 14, 2018 8:31 am
by bgaltd
loosen the bolts on the beech a little and work the bolt back and forward . if it gets better then tighten the bolts back up while working the bolt back and forward . if it goes stiff again (the bolt , you dirty buggers
) just loosen off the bolts
and start again .
please ring me if this doesnt make sense and i'll explain it better
.
rgds.
julian
Re: Newbie
Posted: Wed Nov 14, 2018 8:01 pm
by 143granville
hi welcome .