Hi eveyone this is my first post
i just signed up a few days ago
But have been hard at researching the tx200/hc
Theres so much to read here
So I've bought my new (second hand) tx200hc in 1.77
Which is in great condition,
Only one problem with it, which i have fixed with this forums help
Was the last owner had tightend the stock screws up to much/or put the wrong ones in?
Making it hard to cock or stopping it cocking every time
I'll put another post up about this
Cheers
Mic
Hello all at AAOC
- gary martin
- Posts: 815
- Joined: Thu Feb 19, 2015 8:21 pm
Re: Hello all at AAOC
welcome to the forum. someone will be able to answer your question no doubt.
Re: Hello all at AAOC
Hi Mic,
welcome the forum
Contact Julian on here http://www.airarmsspares.com/
He will sort you out with the correct stock screws.
welcome the forum
Contact Julian on here http://www.airarmsspares.com/
He will sort you out with the correct stock screws.
HW100T .177
AA Prosport .177
AA S200 .177 Huma Reg
AA Prosport .177
AA S200 .177 Huma Reg
- Blackbaronfish
- Posts: 3690
- Joined: Sun Feb 15, 2015 6:20 pm
- Location: Nuneaton
Re: Hello all at AAOC
Welcome to the AAOC
BBF
BBF
Did I mention that I'm the only one to have attended EVERY meet since we started
Re: Hello all at AAOC
Thank you all for the welcome
And advice i think I'm going to try stainless steel for the stock screws
But i could change my mind lol
Cheers
Mic
And advice i think I'm going to try stainless steel for the stock screws
But i could change my mind lol
Cheers
Mic
Who is online
Users browsing this forum: No registered users and 81 guests