Air Arms Owners Club

Hello guys, I've a air arms s200mk3 and have bought a pressure guage for it but need the little tool that looks like a big nut that goes over the gold fill valve and locks on in the 2 holes with 2 steel bars, which then allows me unscrew the valve from the cylinder, I was wondering if any of yous had one of those little tools I could buy? As I've tried all over the internet and they are all out of stock, many thanks brendon

Leave a message for Julian in the spares section I'm sure he can get you one .

Hi mate, thankyou I've just posted mate

A decent set of circlip plyers will do the job,or if you have access to a jigsaw and welder you Can make one like I did.on the same design of a angle grinder spanner.

http://www.altaros.cz/en/cz/10-regulato ... /|demoTab3

Scroll down when the link opens and look at the 3rd tab - Instructions