Warm up shots for TX200

no avatar
FPoole
Posts: 286
Joined: Mon Feb 16, 2015 2:37 am

Warm up shots for TX200

Wed Oct 18, 2017 12:42 am

I have solved the long sought after question of, "How many warm up shots to get the poi back to normal?" The answer is 3. I have let my current FT TX sit for right at 6 months without touching it. I finally had to get in a few shots. The first 3, at 25m, were one ragged hole, but .5" high. I aimed .5" low for the next shot and it hit .5" low. I shot 3 more at the bull and all went in the bull very tightly. I moved out to 50m and the first shot hit at 9 o'clock with perfect elevation. There was a slight cross wind, so I aimed at the 3 o'clock edge and hit almost dead center. The next shot hit right on 3 o'clock due to a drop in the slight breeze. I kept my aim at the 3 o'clock edge and the next 2 shots were within a pellets width of the last 3 o'clock shot. I was already bored with this gun and went inside. Must be what pcp shooters feel like. The gun is a .177 MarkI, in factory walnut, and a lefty to boot. I've got a few friends with RAW 1000 pcp guns that may be in for a whipping at our first match of the fall.

User avatar
Timmytree
Posts: 868
Joined: Sun Feb 15, 2015 11:50 am

Re: Warm up shots for TX200

Wed Oct 18, 2017 9:44 am

If I leave the Prosport alone for a week or 2 I always put a couple of shots through the combro, the 1st is nearly always 15 fps higher than normal, 2nd about 10 fps and the 3rd is where it should be!

User avatar
Blackbaronfish
Posts: 2984
Joined: Sun Feb 15, 2015 6:20 pm
Location: Nuneaton

Re: Warm up shots for TX200

Wed Oct 18, 2017 10:39 am

It’s a good job you lot have three fingers :o :lol: :lol: :lol:

BBF
Did I mention that I'm the only one to have attended EVERY annual meet since we started

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests