Air Arms Owners Club

What power spread do your TX's have?

My .22/HC runs 11.43-11.47fpe, couldn't tell you what that is in FPS though cos I forgot to check...

10.5 to 10.9.all day long on my chrono.rws superdomes. 22.with tinbum kit.

May I ask you what tinbum bits you fitted? I'm of the understanding that the piston runs on delrin rings as standard, so I am wondering where the improvements have been made? Thinking of buying a .177 TX so your help will come in handy at some point.

Thanks

Bobby

dazzler wrote:May I ask you what tinbum bits you fitted? I'm of the understanding that the piston runs on delrin rings as standard, so I am wondering where the improvements have been made? Thinking of buying a .177 TX so your help will come in handy at some point.

Thanks

Bobby

Fiesta pm'd me by mistake I think...

It'll be a top hat/spring guide kit, there will be some slip washers and power washers in there as well...

16.2 fpe.
8.64 H&N FTT at 915fps

Hi ! My Tx is relatively new and has been crono'd a 2 or 3 times between 10.3 and 10.6 which I felt was disappointing as it's sold as a Full Power rifle..... ok I know it won't be 12 !!! But I expected at least low 11's

At that time it had only had about 1000 pellets thru it .... Will it improve ???

Cheers Roj

Roj 252 wrote:Hi ! My Tx is relatively new and has been crono'd a 2 or 3 times between 10.3 and 10.6 which I felt was disappointing as it's sold as a Full Power rifle..... ok I know it won't be 12 !!! But I expected at least low 11's

At that time it had only had about 1000 pellets thru it .... Will it improve ???

Cheers Roj

at1000 cycles, it has in all honesty most likely bedded in by now. is it a full length or HC model. a full length will make power easier. if you are so concerned, contact AA, tell them that you would like a little more, explain you understand the law and are not trying to achieve FAC levels, they will send you free of charge some power washers.

Oh Right !.... thanks very much for the info, its really appreciated. It is an HC so I am aware that they produce slightly lower figures. Obviously I need a margin to keep below the magic 12 No ! If they'll provide some washers that would be great as I have access to crono's at the club and my local dealer.

Thanks again !
Roj

PS : Thanks Gary, before I do anything I'll get a few more Crono's done of the latest figures to be sure of the No's and then perhaps contact AA, as in the near future I'm planning on doing a bit of hunting, ..... as FPS means Prizes : -)

Cheers
Roj