pulled out an old TX yesterday

no avatar
Posts: 278
Joined: Mon Feb 16, 2015 2:37 am

pulled out an old TX yesterday

Mon Dec 05, 2016 11:35 pm

It's a lefty, walnut MarkI that I've been neglecting. I bought the gun, with at least a couple hundred thousand shots on it, from an old FT shooter. It had a plastic tophat that had become stuck, so I put it aside. I finally got the top hat out of the MarkII FAC piston that came with the gun. These are about 93 mm stroke, so just 5 mm shorter than the MarkIII. I changed this for a standard 84 mm stroke MarkI piston and used the seal that was on that piston. The seal was a little less tight and of a harder material, but it sealed perfectly. The gun was quick with a sharp shot cycle that I just didn't like. I pulled it apart and put the seal from the first piston, which is more pliable and tighter. The shot cycle is soft and smooth, but a little more lazy. That's the way I like them. I'm always amazed that just a small change can make such a difference to the feel.

User avatar
Posts: 2922
Joined: Sun Feb 15, 2015 6:20 pm
Location: Nuneaton

Re: pulled out an old TX yesterday

Tue Dec 06, 2016 6:33 am

Yes I've done the same with a Cometa 400. Small changes but big difference,Just changing lube can throw you off :o
But then that's what tuners tend to do...and that's what you end up paying for :o
Did I mention that I'm the only one to have attended EVERY annual meet since we started

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest