S200 Tuning question.
Posted: Tue Jul 04, 2023 9:36 am
I have an S200 with the 2 piece stock. It's .177 and I am looking to install a regulator in it. I would like to run it under 12 ft/lb. I am in NZ and going over that isn't an issue, but I want it sub 12 .
Currently I can't get it over 10.5/11 ft/lb. I have the venturi screw out and hammer in as far as it will go before it won't cock. I filled the tank to about 200 bar and shot about 20 to 30 shots, it started around 8 ft/lb then slowly increased to 10 after about 20 - 30 shots. I was using 8.64 grn H&N.
Is there something else that can restrict these that I can change to bring the power up that little bit more? I believe around 13 ft/lb is the max output for these lovely guns.
Currently I can't get it over 10.5/11 ft/lb. I have the venturi screw out and hammer in as far as it will go before it won't cock. I filled the tank to about 200 bar and shot about 20 to 30 shots, it started around 8 ft/lb then slowly increased to 10 after about 20 - 30 shots. I was using 8.64 grn H&N.
Is there something else that can restrict these that I can change to bring the power up that little bit more? I believe around 13 ft/lb is the max output for these lovely guns.