Barrel screw torque?
Posted: Fri Mar 11, 2022 12:29 pm
Howdy folks.
I recently discovered that one of the screws holding the barrel in place on my HFT500 had backed out a bit. I screwed it back in and attempted to match the torque of the other two screws, but I would love to torque it to factory spec.
Does anyone know what the proper torque should be or where I might find such information?
Thanks.
I recently discovered that one of the screws holding the barrel in place on my HFT500 had backed out a bit. I screwed it back in and attempted to match the torque of the other two screws, but I would love to torque it to factory spec.
Does anyone know what the proper torque should be or where I might find such information?
Thanks.