Barrel screw torque?

no avatar
AllenCorneau
Posts: 7
Joined: Mon Feb 01, 2021 3:23 pm

Barrel screw torque?

Fri Mar 11, 2022 12:29 pm

Howdy folks.

I recently discovered that one of the screws holding the barrel in place on my HFT500 had backed out a bit. I screwed it back in and attempted to match the torque of the other two screws, but I would love to torque it to factory spec.

Does anyone know what the proper torque should be or where I might find such information?

Thanks.

no avatar
Roger5
Posts: 1071
Joined: Sat Jul 25, 2015 8:04 am
Location: Hampton middlesex

Re: Barrel screw torque?

Fri Mar 11, 2022 8:43 pm

I wouldn't over worry, just nip it up, if your really concerned, give airarms a shout. Rog

no avatar
wellhouse
Posts: 5
Joined: Fri Mar 18, 2022 11:41 am

Re: Barrel screw torque?

Wed Apr 20, 2022 5:27 pm

The 3 screws on the top and the one on the bottom were just nipped up on mine when the barrel was changed, i put them back the same - just nipped up. The barrel is quite a tight fit anyway so you definitely don't need to go crazy.

Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests