S410 classic head scratcher

no avatar
Blinkybob
Posts: 3
Joined: Mon Mar 11, 2019 6:45 pm

S410 classic head scratcher

Mon Mar 11, 2019 8:28 pm

I am having a few problems with my second hand s410 classic 2007. The power is about 10ft/lbs with aa diab fields and i would like it a little more. I have fully serviced the rifle and installed a new exhaust vale and new hammer spring. When I stripped the rifle I found the old spring had and extra little spring on it to boot power but it was still under 9.7ft/lbs then. The exhaust port adjuster screw is full out with no obstruction. The exhaust valve spring can not be wound out any more without air leaking out the barrel.
Any help would be appreciated as I am stumped.
Thanks

no avatar
Roger5
Posts: 1071
Joined: Sat Jul 25, 2015 8:04 am
Location: Hampton middlesex

Re: S410 classic head scratcher

Mon Mar 11, 2019 10:34 pm

Is that from a 190bar fill, these guns don't get into their sweet spot until about 160bar, what I'm saying is at 190bar it will probably only be doing 10ftlb but at 160bar it could be 11ftlb +

no avatar
TenMetrePeter
Posts: 1043
Joined: Wed Jun 29, 2016 5:40 pm
Location: Luton Beds UK

Re: S410 classic head scratcher

Tue Mar 12, 2019 10:38 am

You probably did this but ensure the hammer rail is polished and free from any oil or grease. It must be dry.
The hammer spring must be the standard one. There are low power springs and hammers.

Post Reply

Who is online

Users browsing this forum: No registered users and 18 guests