S200 power fluctuations help
Posted: Thu Nov 22, 2018 6:25 pm
I have read a few discussions about setting up a s200 with a regulator and have tried most of the suggestions.
I have a mk1 and have fitted an external Huma regulator. Also fitted a new hammer spring.
Winding the venturi screw out and the hammer spring in doesn't alter the ft lbs much.
I have tried the regulator at 93 (as it comes)and a bit higher, up to 100. The transfer port valve I have tried screwed all in then backed out 1 1/2 turns, 3 turns, 10mm depth and 6.5mm depth.
At one point it registered 13.1 ft lbs 3 shots in a row, then dropped to 8.4 ft lbs without me making any changes for the next 8 shots.
Suggestions?
I have a spare unregulated cylinder that hasn't had anything done to it, that is around 7.5 to 8 ft lbs.
I have ordered a seal kit.
Ideas greatly appreciated.
Ta
I have a mk1 and have fitted an external Huma regulator. Also fitted a new hammer spring.
Winding the venturi screw out and the hammer spring in doesn't alter the ft lbs much.
I have tried the regulator at 93 (as it comes)and a bit higher, up to 100. The transfer port valve I have tried screwed all in then backed out 1 1/2 turns, 3 turns, 10mm depth and 6.5mm depth.
At one point it registered 13.1 ft lbs 3 shots in a row, then dropped to 8.4 ft lbs without me making any changes for the next 8 shots.
Suggestions?
I have a spare unregulated cylinder that hasn't had anything done to it, that is around 7.5 to 8 ft lbs.
I have ordered a seal kit.
Ideas greatly appreciated.
Ta