Page 1 of 1
S410F Barrel removal
Posted: Mon Aug 07, 2017 1:18 pm
by supergnome
After a drop I would like to remove the barrel to check if its straight. Its newish with the rose bud shroud and AT'd all over.
Is it 2 top grub screws or is there 1 underneath as well? Will it be glued in? David.
Re: S410F Barrel removal
Posted: Mon Aug 07, 2017 3:59 pm
by Archer50
There is a small grub screw underneath.
As far as I know, you will have to remove the AT caps to get at it, but not necessarily the AT on the power adjuster (which is the problematic one). This will void any warranty you have left on the gun, but then so would removing the barrel anyway. The barrel is not normally loctited or glued in.
I hope it's not bent, but at least it is usually pretty easy to straighten if it is.
Alan
Re: S410F Barrel removal
Posted: Mon Aug 07, 2017 5:31 pm
by supergnome
Thanks for that Alan. It has 5 months of warranty left but I think I'll get it started. When you say the power adjuster do you mean the hammer spring tensioner or the side screw over the transfer port? David.
Re: S410F Barrel removal
Posted: Mon Aug 07, 2017 10:26 pm
by Roger5
supergnome wrote:Thanks for that Alan. It has 5 months of warranty left but I think I'll get it started. When you say the power adjuster do you mean the hammer spring tensioner or the side screw over the transfer port? David.
He means the side screw over the transfer port, and yes they can be a pain to remove. Rog
Re: S410F Barrel removal
Posted: Tue Aug 08, 2017 3:58 pm
by Archer50
Roger5 wrote:supergnome wrote:Thanks for that Alan. It has 5 months of warranty left but I think I'll get it started. When you say the power adjuster do you mean the hammer spring tensioner or the side screw over the transfer port? David.
He means the side screw over the transfer port, and yes they can be a pain to remove. Rog
I do, and it is
