Page 1 of 2
S410 Firing problem.
Posted: Sat May 20, 2017 6:19 pm
by Stallard1982
So I seem to have double loaded my S410 .177 while testing out some Jsb Beast pellets, bit of a silly idea using 16 grain pellets in a .177 anyway I know
.
The bolt is pulled back all the way and seems cocked, but it wont fire?
Any ideas what the hell I've done guys?
Please help...
Re: S410 Firing problem.
Posted: Sat May 20, 2017 8:09 pm
by Outandabout
A daft question but is the gun charged. Just because the gauge is reading a pressure does not mean it has air in. Try putting a little air in and try again.
Kevin
Re: S410 Firing problem.
Posted: Sat May 20, 2017 8:52 pm
by Blackbaronfish
Take the side plate off and check the sears
BBF
Re: S410 Firing problem.
Posted: Sat May 20, 2017 8:52 pm
by Stallard1982
Yes the gun is charged.
Re: S410 Firing problem.
Posted: Sat May 20, 2017 8:54 pm
by Stallard1982
One I've taken the guard off what am I looking for with the sears?
Re: S410 Firing problem.
Posted: Sat May 20, 2017 9:19 pm
by Outandabout
There's a good vid on youtube. Check it out. Look for "S410 trigger sears". Watching it is easier then explaining it.
Cheers
Kevin
Re: S410 Firing problem.
Posted: Sun May 21, 2017 7:10 am
by Mark112
Be careful though as you potentially have a loaded gun. Double loading itself is not a problem ... the pellets will fire out the barrel just fine. Unless you have put a whole magazines worth down the barrel!
Re: S410 Firing problem.
Posted: Sun May 21, 2017 3:28 pm
by Stallard1982
All sorted now guys thanks for all the help.
Re: S410 Firing problem.
Posted: Sun May 21, 2017 3:58 pm
by Outandabout
What was the problem
Re: S410 Firing problem.
Posted: Sun May 21, 2017 8:05 pm
by Stallard1982
The top sear was in wrong position.