Air Arms Owners Club

Advice please, I've recently bought a second hand S200mk2 as I've heard so much about them, it has the T-bar filling adaptor and when I went to fill the gun it was leaking from the base of adaptor, I've replaced the two rubber seals at the end of the cylinder but it's still leaking and will not fill as the pressure doesn't get high enough to open the valve. I'm suspecting the actual adaptor but it looks fine, anyone experienced this before ?

Paul.

Hello paul
Cock the rifle before filling get some pressure in there and place a ballon over the adaptor just too check thats where the air is leaking from.
If you require spares contact bgaltd on here or best fittings if julian cant help you out.

Thanks for the advice, I've located the problem, it is the actual fill adaptor ( I borrowed a new one and it worked perfect )

Paul.