maybe a silly question/found 4 washers after loading bolt change

[tapps]

i recently replaced the original loading bolt with a rowan engineering black one, it took a bit of heat,alot of pulling & a bit of up & down movement to get the original OFF,i came across 4 small dark coloured washer's on the floor, have they came from in innards of my s410,it loads & fires the pellet without any problem,i ain't got a clue where they came from, a little worried to say the least !!!!! ,can someone put my mind at rest.

[Blackbaronfish]

What size, material are they

BBF

[tapps]

9mm in diameter, the hole is 4.5mm,they are dark steel.

[Roger5]

The only washer I know of on an S410 is on the stock bolt, I've never seen any others

[tapps]

i think they are from something else, just seem's strange that i came across them when i did i've looked on CHAMBERS s400/s410 parts diagram, cant see anything on there.

[Roger5]

I reckon, if it cocks , loads and fires, doubt that there's a problem.
But if it falls to bits, I was wrong
I'm pretty sure it's fine

[tonyc]

I take it they are too large to have come with the Rowan handle? Do you have scope mounts or other fittings with M4 bolts?

[143granville]

if it shoots fine keep them safe .

[tapps]

I take it they are too large to have come with the Rowan handle? Do you have scope mounts or other fittings with M4 bolts?

mystery solved, the 4 washers were off a pair of sports match mounts,i ordered high sports match mounts & they were on them.so i presume they were also on the medium mount's.

[Raj]

You can always rely on Charlie to fix it f you are worried about them waskers ....
https://www.youtube.com/watch?v=3EIPDBNSq5A