Hello all, I am a newbie to Air Arms and whilst there are plenty of videos on YouTube showing how to strip down the S400 series, there don't seem to be any showing reassembly (perhaps I'm just not looking hard enough)
I just stripped down a 2nd hand S410 as it was a little low on power. I just went as far as cleaning off the hammer rail (easy enough as the previous owner had removed the AT blanks) the rail was mucky as anything. However on reassembly I've struggled to:
- get the bolt to reliably engage the hammer and cock it
- get the magazine indexing mech to engage with the bolt!
- the action / trigger unit has ended up very very slightly skew to the air cylinder, so the fit to the stock isn't quite right.
Feels like it should be straightforward, but I can't seem to find anything online, your help would be greatly appreciated!
Regards
R
S410 Reassembly
Re: S410 Reassembly
Put in your location, there might be someone near you who can help you with it. Rog
- TenMetrePeter
- Posts: 1043
- Joined: Wed Jun 29, 2016 5:40 pm
- Location: Luton Beds UK
Re: S410 Reassembly
It can be a problem where no dowels or milled locations are provided. All I can suggest is loosen all the bolts, tighten finger tight, realign the parts and check the relevant fit or hammer or mag operation, and then retighten gradually like you would a cylinder head, a tweak at a time checking the fit etc as you go. You may have to strip it all to get to the underneath trigger block screw (s).
Re: S410 Reassembly
Thanks for the replies so far. I'm based in Cambridge
Re: S410 Reassembly
Did you get a users handbook with the rifle, if you didn't airarms will send you one, but you will have to send them a stamped addressed envelope 6" x 9" should do it. It will make it easier to identify part numbers so you can be talked through reassembley procedure, they are pretty easy once you know how. Rog
Re: S410 Reassembly
Helpful tip, thank you. Do you think it might be available online? If not I'll send off for one!
Re: S410 Reassembly
Russfx wrote:Found one https://www.google.co.uk/url?sa=t&sourc ... n7ISzjwUm3
All Air Arms manuals are free to down load from their web site https://www.air-arms.co.uk/downloads no need to go looking
AA FTP900, AA HFT500, AA S510, FWB-800FT
- TenMetrePeter
- Posts: 1043
- Joined: Wed Jun 29, 2016 5:40 pm
- Location: Luton Beds UK
Re: S410 Reassembly
gdavison wrote:Russfx wrote:Found one https://www.google.co.uk/url?sa=t&sourc ... n7ISzjwUm3
All Air Arms manuals are free to down load from their web site https://www.air-arms.co.uk/downloads no need to go looking
Amazing that people sell them on Ebay for £10 and they are probably reprints of the pdf.
Re: S410 Reassembly
TenMetrePeter wrote:gdavison wrote:Russfx wrote:Found one https://www.google.co.uk/url?sa=t&sourc ... n7ISzjwUm3
All Air Arms manuals are free to down load from their web site https://www.air-arms.co.uk/downloads no need to go looking
Amazing that people sell them on Ebay for £10 and they are probably reprints of the pdf.
I can do them for 9 Quid ...

AA FTP900, AA HFT500, AA S510, FWB-800FT
Who is online
Users browsing this forum: No registered users and 81 guests