aa s410 carbine .22

no avatar
weebster
Posts: 10
Joined: Fri Nov 25, 2016 9:35 pm

aa s410 carbine .22

Fri Nov 25, 2016 9:44 pm

Hi all,although this might seem like a first post it isn't,for some reason I had to re-register even though I have been signed in under this user name since the new board went up.

Anyway I have a vgc aa410k in .22 with one problem....it shoots high and to the right so is being sold as a project,it holds air perfectly,cycles the mag perfect,no rust and it's pre-anti tamper,beech stock inc silencer,its doing 10.5ftlbs with aa pellets.
I have no idea why it's shooting the way it is,the guy I purchased it off said it had a service about 14 months ago by his local gunshop,whether theres a certain way the barrel is fitted on these I don't know as I'm not into gun smithing on pcp's
it's in vgc tbh just this poi problem.
There appears to be no 'o' ring in the top of the barrel band,I don't know if that would really make any difference to the problem.

asking £300

I will post some pics later.
Last edited by weebster on Sat Nov 26, 2016 6:51 pm, edited 1 time in total.

no avatar
eboswan
Site Admin
Posts: 2905
Joined: Sun Feb 15, 2015 9:16 am
Location: swansea

Re: aa s410 carbine .22

Fri Nov 25, 2016 9:51 pm

Please fill out your location in your profile. :)
IS MY SIGNATURE BIGGER THAN RAYS. Cz 452 american .22+sak mod
S200. .177

no avatar
weebster
Posts: 10
Joined: Fri Nov 25, 2016 9:35 pm

Re: aa s410 carbine .22

Fri Nov 25, 2016 10:36 pm

Damn....I knew there was something else I had to do when re-joining,done now....thanks for the heads up ;)

no avatar
weebster
Posts: 10
Joined: Fri Nov 25, 2016 9:35 pm

Re: aa s410 carbine .22

Sat Nov 26, 2016 6:45 pm

WITHDRAWN FROM SALE....SEE POST BELOW.
Last edited by weebster on Tue Nov 29, 2016 12:58 pm, edited 1 time in total.

no avatar
weebster
Posts: 10
Joined: Fri Nov 25, 2016 9:35 pm

Re: aa s410 carbine .22

Tue Nov 29, 2016 12:35 pm

Well after cleaning the barrel and finding that the barrel retaining screws were not done up,the front retaining screw wasn't done up at all and the rear was barely holding the barrel I have again put 40 odd shots through after sorting the former,and it now shoots spot on :D ...1 hole groups smaller than a 20p at 27 yds and no more shooting high to the left/right...it now shoots dead straight.
So it looks like whoever gave this rifle a service last OR the guy I got it from had messed with it hadn't put it back together properly.

Therefore this rifle is now withdrawn from sale as I shall be keeping this little beauty :D

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests