they state zero at 15 yards,then adjust the scope at your desired zero range, if it's out by a fair bit,then shim the scope,to high the front mount, to low the rear mount.i've never bothered previously.,when all sighted in put your turret's to zero.

this is in my mamba pro 2 5-30x50 manual... SHIMMING. ideally your scope should be zeroed to your rifle as near to the middle of it's adjustment range as possible, on some rifles to achieve this it is necessary to 'shim' the lower cradle of the rear (or front)mount using a thin sliver of silver foil...

do you bother using a pellet lube,or do you just use the pellet's straight out of the tin.i've used LT1 pellet lube & daystate rangefinder in the past.is there a benefit in using either.

Hello, I just purchased a S410 carbine Superlite, it comes on Thursday, I just hope I have bought a good gun. I have a Weihrauch moderator with a 1/2" UNC fitting, is there an adaptor to fit the S410 carbine? best fittings silencer adaptor 10mm suits Air Arms s300/s400/s410 or a cheaper option woul...

i have a MTC mamba pro 2 2-12x50i on my weihrauch .22 hw100 ratting set up, i really like the SCB2 reticle,i have a hawke eclipse S/F 6-24x50 on my new .177 air arm's S410,the IR is playing up i''ve changed the batteries several time's,some time's it will light up, not that often though,so i've bit ...

i noticed on the inside of the stock where the cylinder sits there was epoxy glue covering the hole where the QD STUD was fitted, inside the stock, look's to me like he was heavy handed and gone straight through, i hope he had sense to remove the action/cylinder prior to drilling the hole,i cleaned ...

Roger5 wrote: ↑

Wed Jul 29, 2020 8:33 pm

You can buy threaded studs, and then you can use a nut from the inside of the stock
I certainly wouldn't be trusting araldite
I've done this before on A/A stocks and it worked ok

can you tell me where to get one from, can you send me a link.thank's

i got a 2nd hand beech stock from a well known auction site, it looks in good condition considering it's 2nd hand,it had QD STUD'S already fitted !!! when i attached my harris bipod, it wouldn't tighten up properly & the stud started to pull out of the pre drilled hole, looks like they used the wron...

i'm looking at another scope to purchase,i generally use uttings.com for 99% of my airgun stuff, the scope i'm interested in is £40 cheaper from www.opticswarehouse.co.uk,has anyone on here had good results from them or should i stick with uttings.

I take it they are too large to have come with the Rowan handle? Do you have scope mounts or other fittings with M4 bolts? mystery solved, the 4 washers were off a pair of sports match mounts,i ordered high sports match mounts & they were on them.so i presume they were also on the medium mount's. :D