Hello, I am in need of a cylinder for a S200, not worried about the length, must have the valve at the breech end. Not fussy about cosmetics but must be servisable.
Thank you.
ATB.
Geoffrey Gould.

Hello, I am looking for a S200 preferably in .22 cal. It does not have to be smart but it does have to be complete. I have some ideas for mods. etc. and dont wish to wreck my S200 keeper if the mods dont do what I want. I would even go for one without a stock if pushed. WHY please? Thank you. Cheers...

Hi tight is not the word for it, almost took the vice off the bench.Then got a large cloth and soaked in boiling water and wrapped round the tube, waited for a few minutes and it still took a 2' lever to shift it. Once cracked then only finger tight.
Best of luck.
Cheers.
Geoff.

Hello. Well I am wondering if I have something a little different, this was new from the factory this year. Removing an end cap from the air tank then I have found that the O ring is 70% thicker, in section, than the ones supplied in a set of spare seals. Being curious I removed the other end and th...

Hello neil , not knowing a lot I was wondering if there were any differences in the O rings, my 200s is new and the O ring was very sloppy which didn't help much. Got a pack of spare ones and they were the same. Dangling out of the slot in the probe ( bolt not sure what to call it?) meant that they ...

Hello I have only had a s200 a short time and so has my neighbor.He has a multi shot adapter and it was destroying the O rings very quickly. Looking at the shape that the O ring goes because of the wide groove in the face of the magazine it acts like a gillatine. My answer was to use a tapered reame...

Hi EUROSHOOTING in Prague may be of some help, I know they do the 200S Hunter and seem to have good contacts with the CZ factory. Contact Miroslav Varga, a very helpful chap. English no problem.
Cheers.
Geoff.