Right oh. I will sit in the back garden tomorrow and have a plink. Will go from 180 until it drops off.
Cheers

Again, sorry to sound a bit special, but which item is the firing valve? Is it the larger brass looking cylinder with the screw tread which sits in the air cylinder? Also which bit deforms?
Cheers
Shaun

I have polished the rail, following the YouTube link mentioned in previous threads. Also the trigger and adjusted it. I will look at doing the string with my combro at the weekend, as it was a little higher than I would have liked it earlier!

I have just had my combro fixed and calibrated by the guys. It took a chat and 7.50. The service and turn around time was superb!

So I have it at quite a Good zero at 25m in the back garden. The only problem I have now is a massive fluctuation in power. About 1.5flb between 180 and 120 bar. Does any one have any ideas what could be wrong, or is it just settling in post fiddling?
Cheers in advance

Cheers for you help people. It would seem that the moderator was causing the problem. So next question, is it broken, do I need another one or am I being special and there is an easy way to eliminate the problem?
Cheers again

granville wrote:worth putting your location on my be some one close who could help.

Good shout. It should be up now
Cheers

I have the original kicking around. I will try that when I'm off work next week. Cheers for the ideas, they are greatly received.

I never though about the scope as it's quite new, however.....
What do I need to do with the band and seal? They are both new?
Sorry to seem a little special. I'm new to this.

Here goes. I purchased an 2005 s410 as a project a few months ago. Since then I have replaced all seals and gave it a Polish. The power is good according to my combro, however the thing just won't zero. (Itts not the operator I promise!) The point of impact changes at 25 yards wildly to each side of...