I've added 0.1mm to the shim (total now of 0.24mm) and nipped it down real tight with some soft jaw grips and it's spot on now and keeps a pretty consistent barrel to cylinder gap now. I chrono'd it this morning at 12.1ft/lbs :oops: I followed the manual and set the hammer spring screw flush with th...

Good idea with the screw! You were lucky to nab those for free! I've been re-assembling today with the Crono on the list for tomorrow. I've got a small issue with the barrel and cylinder alignment though. It seems that when it's on the bi-pod the cylinder flexes up causing the barrel and cylinder to...

That looks awesome! I've not done too much with my stock. I've put an adjustable cheek piece in, adjustable butt plate and then I've just rounded the stock off a little, not enough to change it's looks but enough to make it feel a bit nicer in use. I've used a router bit to round the fore-end off sl...

Thanks for the reply Raj! It's typical that I took it apart and reassembled it before deciding to drill the transfer. When I went to put it all back together, I put the striker pin back in with the cirlip and realised I needed it out to put a 3.5mm pin up through the transfer port to do the barrel a...

Thanks for the help Raj! I've gone for the Lane Mk9 external that I was able to source from Rat Works as Lane is away on holiday. So Far I have: Drilled the transfer and barrel to 3.5mm Set the choke to flush and filed the end flat to reduce vortexes Aligned the transfer port and the barrel set the ...

Just a quick update! Spent the whole day doing the rebuild. Fixed a lot of small issues, polished the bolt, reset the trigger etc. The small aluminium tube on the outlet valve was loose and not really attached... I'm now in the market for an external regulator for it, HUMA is out of stock, Lane is a...

Hi Everyone, Before we start I know this is a "dodgy topic" and I am aware of all the laws etc. Anyway, down to business. My S200 is coming up on 15 years old now and the cylinder is leaking (around 30 bar a day loss) and I think the little aluminium tube on the inside on the outlet valve has come l...