Hi,

I have the above rifle, I have been looking to fit a sling . Been scouring the internet for a fitting kit to no avail.

Any ideas?

Cheers in advance

Job Done, Come on! Piston seal,rear and front bearing and both breach seals replaced and WW kit fitted. Running a little cold at the moment, just over 9flb's Piston seal was a very tight fit, so hopefully will bed in Thanks for all your help.Can't wait to get it to the range tomorrow (Ford). Cheers ...

Raj wrote:Good wood !!

Funnily enough Raj.. Goodwood is only 6 miles away

9 coats and finished.

Found one here.

http://www.ebay.co.uk/itm/Air-Arms-TX20 ... 58c10e53d0

As it is walnut, and after a little hesitation I decided to go old school on this stock. Boiled linseed oil, and I'm so glad I did. Stock in the picture below (Although, doesn't do it justice) has had three coats of boiled linseed oil and at every layer has been rubbed down with 0000 grade wire wool...

I'm looking at th MTC Viper or the mamba lite or possibly, a hawke Varmint.

Any suggestions ?

Cheers
Nick

Right, Next Stage. Whilst waiting for the Welsh Willy to arrive, I decided to strip and re finish the stock. Luckily, there where no major dings or scrapes to worry about. Initially, used a mild detergent mix with a sponge scouring pad then allowed to dry, then followed white spirit with wire wool t...

Thank you Roadrunner / Eddie / Timmytree / Doggo for all your help.

I am now just waiting now for the Welsh Willy kit to arrive.

Cheers and thanks again.

Nick

Hi, Quote from the Welsh Willy site. (m) " I use Titan springs in the kits and have found they give excellent results, the Titans are all cut to ensure they give close on the exact performance the shooter needs, so you don’t have to do any cutting of springs, all thats taken care of." Mayb...