Search found 36 matches

by Pete2
Thu May 28, 2020 5:33 am
Forum: TECHNICAL
Topic: Pro target barrel diameter
Replies: 0
Views: 832

Pro target barrel diameter

Does anyone know the diameter of the Pro Target barrel?
Thanks
by Pete2
Tue May 26, 2020 8:36 pm
Forum: Welcome back
Topic: Hello
Replies: 5
Views: 623

Re: Hello

Hi and welcome to the forum.
What parts did you need to convert from one to the other?
by Pete2
Tue May 26, 2020 8:35 pm
Forum: Off topic chat
Topic: Where is everyone?
Replies: 24
Views: 1412

Re: Where is everyone?

Same here, check the forums every 2 or 3 days, comment if I can help.
by Pete2
Sun May 24, 2020 9:34 pm
Forum: TECHNICAL
Topic: S200 cylinder internals
Replies: 4
Views: 344

Re: S200 cylinder internals

by Pete2
Sat Apr 11, 2020 6:32 am
Forum: Wanted Section
Topic: S200 mk3 brass cocking bolt
Replies: 1
Views: 4110

Re: S200 mk3 brass cocking bolt

There are some brass ad-ons on eBay if you have no luck here.
by Pete2
Tue Mar 31, 2020 5:57 pm
Forum: TECHNICAL
Topic: Pro target breech block
Replies: 0
Views: 11350

Pro target breech block

Can anyone with a pro target check something for me please.
When the rifle is loaded, how tight is the breech block on the stub of the barrel?
Is there any play forwards or backwards?
by Pete2
Sat Feb 22, 2020 11:31 am
Forum: General airgun chat
Topic: HFT 500 barrel clean
Replies: 8
Views: 7549

Re: HFT 500 barrel clean

Can't remember the make of my pull through but it is a bit stiff, still flexible though.
I have pulled through the barrel of my 500 a few times without removing the stripper.
Most of the time I only fire 3 felts through if the accuracy goes.
by Pete2
Thu Feb 20, 2020 8:37 pm
Forum: TECHNICAL
Topic: Power Curves & the Sweet Spot
Replies: 26
Views: 33210

Re: Power Curves & the Sweet Spot

Cheers for the replies.
by Pete2
Mon Feb 17, 2020 10:33 am
Forum: TECHNICAL
Topic: Power Curves & the Sweet Spot
Replies: 26
Views: 33210

Re: Power Curves & the Sweet Spot

Cheers Tony.

I'm going to experiment. I will try the pot length 1st - longer and shorter, to see what difference it makes.
I have not measured the length currently, just followed Ray's guide.
by Pete2
Sun Feb 16, 2020 4:29 pm
Forum: TECHNICAL
Topic: Power Curves & the Sweet Spot
Replies: 26
Views: 33210

Re: Power Curves & the Sweet Spot

The sweet spot on my 177 s200 is from 155 to 110. It goes from 770 to 790 and back down. Will just increasing the hammer then using the venturi allow me to extend it and make it flatter? I would like it to go from 165 and have a less fps variance.
Or do I need to increase the pot length?